Manual.ly Logo

Tunturi Cardio Fit T40 Manuale

0,0 · 0 Valutazioni

Manuale PDF · 104 Pagine

Italiano

M: OA-GPT-5-NAN
pagina

/ 104

Loading...
325bce7b84296c8bf87497c52ade899799ea page 16
22
English
Belt Dust
This occurs during normal break-in or until the
belt stabilizes. Wiping excess off with a damp
cloth will minimize build-up.
General Cleaning
Dirt, dust, and pet hair can block air inlets and
accumulate on the running belt. On a monthly
basis: vacuum underneath your treadmill to
prevent buildup. Twice a year, you should remove
the black motor hood and vacuum out dirt that
may accumulate.
UNPLUG POWER CORD BEFORE THIS TASK.
Belt adjustments
Adjustment must be made from the rear roller.
The adjustment bolts are located at the end of the
step rails in the end caps.
- Tighten the rear roller bolts (clockwise) only
enough to prevent slippage at the front roller.
Turn both running belt tension adjustment
bolts in increments of 1/4 turn each and inspect
for proper tension by walking on the belt at a
low speed, making sure the belt does not slip.
Keep tensioning the bolts until the belt stops
slipping.
- If you feel the belt is tight enough, but it still
slips, the problem may be a loose Motor drive
belt under the front cover.
- Do Not Over-tighten
Over tightening will cause belt damage and
premature bearing failure.
Running belt tracking adjustment
The performance of your treadmill is dependent
on the frame running on a reasonably level
surface. If the frame is not level, the front and
back roller cannot run parallel, and constant belt
adjustment may be necessary.
The treadmill is designed to keep the running belt
reasonably centered while in use. It is normal for
some belts to drift near one side while the belt is
running with no one on it. After a few minutes of
use, the running belt should have a tendency to
center itself. If, during use, the belt continues to
move toward one side, adjustments are necessary.
Exception:
During rehabilitation where the user is using one
leg much stronger than the other, it might happen
that the running belt drifts to one side. In these
cases you should not adjust unless the running
belt does not centre itself during normal condition
usage.
To set running belt tracking (fig. F-5)
A 10 mm Allen wrench is provided to adjust the
rear roller. Make tracking adjustments from the
left side only. Set belt speed at approximately 3
to 5 kph.
Remember, a small adjustment can make a
dramatic difference!
Turn the bolt clockwise to move the belt to the
right. Counterclockwise to move to the left. Turn
the bolt only a 1/4 turn and wait a few minutes
for the belt to adjust itself. Continue to make 1/4
rotation turns until the belt stabilizes in the center
of the running deck.
The belt may require periodic tracking
adjustment depending on use and walking/
running characteristics. Some users will affect
tracking differently. Expect to make adjustments
as required to center the tread-belt. Adjustments
will become less of a maintenance concern as
the belt is used. Proper belt tracking is an owner
responsibility common with all treadmills.
NOTE
• Damage to the running belt because of
incorrect running-belt adjustments is not
covered by the products warranty.
Troubleshooting
Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it’s
unnecessary to take the whole device in for repair,
as it’s usually sufficient to replace the defective
part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also
the nature of the problem, conditions of use and
purchase date.

Chatta con il manuale del tuo Tunturi Cardio Fit T40 utilizzando l'IA

Ottieni risposte istantanee dall'IA dal manuale del tuo Tunturi Cardio Fit T40

Chiedi qualsiasi cosa sul Tunturi Cardio Fit T40. Le risposte provengono da questo manuale, con le pagine di riferimento.

Cardio Fit T40 Programma di manutenzione

Ricordami quando e' necessaria la manutenzione
Ogni mese
Pulire la cinghia e il piano di corsa

Passare un panno morbido umido o un fazzoletto di carta solo con acqua sul bordo della cinghia e sull'area sottostante. Lasciare asciugare prima dell'uso.

Mostra nel manuale (pagina 21)
Ogni mese
Aspirare sotto il tapis roulant

Utilizzare un aspirapolvere con un ugello di aspirazione piccolo per pulire sotto il tapis roulant ed evitare l'accumulo di sporco.

Mostra nel manuale (pagina 22)
Ogni 2 mesi
Controllare la lubrificazione della cinghia

In base a un uso medio di 60 minuti al giorno, verificare se la cinghia si muove fluidamente e risulta scivolosa; applicare 15-20 ml di lubrificante se necessario.

Mostra nel manuale (pagina 21)
Due volte l'anno
Aspirare l'area del cofano motore

Rimuovere il cofano nero del motore e aspirare lo sporco e la polvere accumulati. Scollegare il cavo di alimentazione prima di questa operazione.

Mostra nel manuale (pagina 22)
Regolarmente
Controllare la serratura delle viti

Ispezionare regolarmente tutte le viti e i dadi per assicurarsi che siano stretti e sicuri.

Mostra nel manuale (pagina 21)

Promemoria di manutenzione gratuiti

In base alla data di acquisto. Sempre gratuito, annulla l'iscrizione in qualsiasi momento.

Inviando, accetti l'informativa sulla privacy. Puoi annullare l'iscrizione con un clic in qualsiasi email.
M: QW-35-FL

Fai una Domanda

0/1000

Consigli Cardio Fit T40?

Sì No

Domande frequenti

A

The treadmill supports speeds from about 1.0 km/h up to 16.0 km/h. Single presses change speed by 0.1 km/h; holding the speed buttons speeds adjustments up.

Questa risposta è utile?

A

The console includes 36 preset programs (P1–P36) and 3 customizable user programs (U01–U03). Each user program supports up to 12 steps and program time ranges from 10:00 to 99:00 minutes.

Questa risposta è utile?

A

Clean the belt edges monthly, vacuum under the treadmill regularly, check lubrication every 2 months (apply 15–20 ml if needed), and follow rear-roller tension and tracking adjustments to prevent slipping and drifting.

Questa risposta è utile?

A

Body Fat is an estimate based on user inputs (sex, age, height, weight, activity) and pulse measured by hand sensors; accuracy depends on consistent, correct hand contact and skin moisture. An "ER" code appears if pulse is not detected.

Questa risposta è utile?

A

Ensure mains voltage matches the rating plate and avoid using RCD/GFCI outlets as they may trip frequently with the treadmill motor. The product must be properly grounded according to local codes.

Questa risposta è utile?

A

Safety features include a safety key (clip to clothing), a master power switch, a circuit breaker, clear warnings, and instructions to stand on side rails before starting; removing the safety key stops the treadmill immediately.

Questa risposta è utile?

A

The warranty covers manufacturing defects under normal recommended use and maintenance. It excludes normal wear, misuse, damage from improper storage or lack of maintenance, modifications, and repairs by unauthorized parties.

Questa risposta è utile?

M: OA-GPT-5-NAN

Vantaggi e Svantaggi

Vantaggi

  • Wide feature set for home use: 36 preset programs, 3 user programs, Body Fat estimation and hot-key shortcuts.
  • Practical maintenance guidance: belt lubrication, tracking/tension adjustment and periodic cleaning instructions.
  • Space-saving foldable design with safety key, master switch and circuit breaker for user protection.
  • Clear console feedback: speed, incline, time, distance, pulse and calories for guided workouts.
  • Suitable speed range (1.0–16.0 km/h) and incline control for varied cardio training and fitness levels.
VS

Svantaggi

  • Not intended for commercial use and limited daily maximum usage (manufacturer guidance ~3 hours/day).
  • Pulse measurement via hand sensors can be inaccurate and requires proper skin contact and moisture.
  • Warranty excludes wear, misuse, improper maintenance and damage from incorrect storage conditions.
  • Avoid using RCD/GFCI outlets—may be inconvenient in some home electrical setups.
  • Requires periodic owner maintenance (lubrication, tracking, tension) which may be unfamiliar to some users.
M: OA-GPT-5-NAN

Prodotto Specifiche

Potenza Motore

1,5 HP Continua

Velocita'

1-16 km/h

Inclinazione

0-10% regolabile elettronicamente

Superficie di Corsa

125x42 cm

Peso Utente Massimo

100 kg

Dimensioni

152x135x70 cm

Dimensioni da Piegato

135x94x70 cm

Peso

51 kg

Caratteristiche

Ruote di trasporto, Rilevazione pulsazioni manuale, Portaborraccia, Pieghevole

M: GO-GEM-FL-25

Descrizione del prodotto Descrizione

Tunturi Cardio Fit T40 Treadmill — Complete Overview

The Tunturi Cardio Fit T40 treadmill is a sturdy home-use running machine built for everyday fitness. Designed for users seeking reliable cardio training, the T40 supports speeds from 1.0 to 16.0 km/h, multiple preset programs, incline adjustment, and pulse monitoring via hand sensors. It accommodates typical indoor home conditions, offers a folding frame for storage, and includes safety features such as a safety key, master power switch and circuit breaker.

Key features and user experience

The T40 delivers a balance of functionality and simplicity. Its console provides quick-start operation, countdown goals (time, distance, calories), 36 preset programs (P1–P36), three user-customizable programs (U01–U03), and a Body Fat estimation routine that uses user inputs and pulse data. Speed and incline hot-keys let you jump to common values quickly, while the display tracks speed, incline, distance, time, pulse and calories during workouts.

Practical features include an auto-sleep console that powers down when idle, foldable design for space savings, and clear assembly/maintenance instructions. The treadmill recommends warming up, exercising within target heart-rate zones (beginner/advanced/expert ranges), and cooling down. Safety and electrical grounding instructions are emphasized: correct mains voltage, avoiding RCD/GFCI outlets, and proper grounding to prevent shocks.

Maintenance and longevity

Tunturi highlights routine maintenance to keep the T40 running well: monthly cleaning around the belt, bi-monthly lubrication checks (apply 15–20 ml if needed), periodic belt tension and tracking adjustments via rear roller bolts, and vacuuming under the motor cover twice yearly. Proper storage (dry, indoor, moderate temperature) and following torque/tension guidance extend belt and motor life. The manual also covers troubleshooting, error codes, spare parts, and safe transport handling.

Safety and warranty notes

The T40 is intended for home use with a specified maximum user weight (manufacturer guidance ~100–110 kg depending on model variant). Users are advised to consult a physician before starting exercise programs, not to exceed recommended session durations, and to supervise use by children or people with disabilities. Warranty coverage addresses manufacturing defects under normal use but excludes wear, misuse, improper maintenance, or damage from incorrect environmental conditions.

Notes

  • The Body Fat function requires holding hand pulse sensors and may show "ER" if pulse is not detected.
  • Keep mains cable clear of moving parts and never use an RCD/GFCI outlet with this treadmill.
  • After lubrication run the belt at ≥5 km/h for 20 minutes before folding to distribute lubricant.
M: OA-GPT-5-NAN

© Copyright 2026 Manual.ly